Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the IMT valve actuator solenoid.
- Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal 2 and ground.
- If the test lamp does not illuminate test the ignition circuit for a short to ground or an open/high resistance.
- Connect a test lamp between the control circuit terminal 1 and the ignition circuit terminal 2.
- Command the IMT valve actuator solenoid ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
- If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the ECM.
- If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
- If the circuits test normal, test or replace the IMT valve actuator solenoid.