Circuit/System Testing
- Disconnect the harness connector at the radio antenna.
- Ignition OFF, test for less than 10 ohms between the terminal 2 outer shield and ground.
- If greater than the specified range, test the antenna coax shield for an open/high resistance. If the coax test normal, replace the radio.
- Ignition ON, test the terminal 2 center terminal for 9.5-11.0 volts.
- If greater than the specified range, test the antenna coax center terminal for a short to voltage. If the coax tests normal, replace the radio.
- If less than the specified range, test the antenna coax center terminal for a short to ground or an open/high resistance. If the coax tests normal, replace the radio.
- If all circuits test normal, replace the radio antenna.