Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2007 >> Vue Red Line, AWD >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Seat Belt System >> Repair Instructions >> Front Seat Belt Buckle Replacement (Quick Connect) >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Shoulder Belt Quick Disconnect Bolt
    GM987242Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
    IMPORTANT: Apply Permatex® 24200 on all restraint fasteners prior to installation.
  1. Install the shoulder belt quick disconnect.

    Tighten:  Tighten the fasteners to 50 N.m (37 lb ft).

    2. Fig 2: View Of Seat Cushion Outer Trim Panel - Front Seat (4-Way)
    GM981027Courtesy of GENERAL MOTORS CORP.
  2. Install the side trim with the fasteners.

    Tighten:  Tighten the fasteners to 2.5 N.m (22 lb in).

    3. Fig 3: View Of Front Seat Back Recliner Trim Panel
    GM981031Courtesy of GENERAL MOTORS CORP.
  3. On the passenger side, install the recliner side cover with the fasteners.

    Tighten:  Tighten the fasteners to 2.5 N.m (22 lb in).

    4. Fig 4: Installing Recliner Handle Trim
    GM981017Courtesy of GENERAL MOTORS CORP.
  4. On the driver side, install the recliner and seat riser covers by firmly pushing on the handle cover.
  5. Install the front seat to the vehicle. Refer to Front Seat Replacement - Bucket .
    6. IMPORTANT: Verify that the shoulder belt is not twisted.
  6. Install the shoulder belt into the shoulder belt quick disconnect.
scientia non olet · About Mike's Workshop Manuals