Installation Procedure
WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Install the battery (3) to the vehicle.
- Install the battery hold down retainer (2) and bolt (1). Tighten the bolt to 15 N.m (11 lb ft).
- Position the positive battery cable to the battery.
- Install the positive battery cable (3) to the battery.
- Tighten the positive battery cable nut (2) to 10 N.m (89 lb in).
- Close the positive battery cable cover (1).
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (LAT) .
WARNING:
Do not tip the battery over a 45 degree angle or acid could spill causing serious personal injury.
CAUTION:
Refer to Fastener Caution
.