Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2007 >> Vue Red Line, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 3.5L (L66) - Introduction (2 Of 2) >> Repair Instructions >> Fuel Rail Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Exploded View Of Fuel Rail Assembly
    GM1237804Courtesy of GENERAL MOTORS CORP.
  1. Install new O-rings to the injectors.
  2. Install the fuel rail and injectors as an assembly to the manifold.
    3. NOTE: Refer to Fastener Notice .
  3. Install the bolts.

    Tighten:  Tighten the bolts to 9.8 N.m (87 lb in).

  4. Connect the fuel injector electrical connectors.
  5. Install the intake manifold. Refer to Intake Manifold Replacement .
  6. Inspect for fuel leaks using the following procedure:
    1. With the engine OFF, turn ON the ignition for 2 seconds.
    2. Inspect for fuel leaks.
    3. Turn the ignition OFF for at least 10 seconds.
    4. With the engine OFF, turn ON the ignition for 2 seconds.
    5. Inspect for fuel leaks.
    6. Turn the ignition OFF.
scientia non olet · About Mike's Workshop Manuals