Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2007 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Manual Transmission) >> Repair Instructions >> Backup Lamp Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac Solstice. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Backup Lamp Switch
    GM880943Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Component Fastener Tightening Notice .
  1. Install the backup lamp switch with a NEW aluminum washer into the transmission case.

    Tighten:  Tighten the backup lamp switch to 44 N.m (32 lb ft).

    2. Fig 2: View Of Backup Lamp Switch Electrical Connector & Oxygen Sensor
    GM1302110Courtesy of GENERAL MOTORS CORP.
  2. Secure the pigtail to the transmission with the tie strap.
  3. Connect the backup lamp switch electrical connector (1) at the pigtail.
  4. Install the front floor closeout panel. Refer to Floor Panel Tunnel Panel Front Closeout Panel Replacement .
  5. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals