Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2007 >> Sky Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Suspension Control System - Suspension Leveling) >> Repair Instructions >> Automatic Level Control Sensor Link Ball Stud Replacement (Twist Axle) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Automatic Level Control Sensor Link Ball Stud
    GM380438Courtesy of GENERAL MOTORS CORP.
  1. Install the ball stud to the rear axle tie rod.

    Tighten:  Tighten the height sensor ball stud to 12 N.m (106 lb in).

  2. Install the automatic level control sensor link to the tie rod ball stud.
  3. Lower the vehicle.
  4. Install the ELC/TRAILER fuse.
scientia non olet · About Mike's Workshop Manuals