Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Install the recirculation actuator levers (3, 6), if necessary.
- Install the recirculation actuator (7).
- Install the recirculation actuator bolts/screws (1).
Tighten: Tighten the screws to 1.2 N.m (11 lb in).
- Connect the recirculation actuator electrical connector (1).
- Install the upper I/P trim pad.
- Re-calibrate the actuators. Refer to Actuators Recalibration .
NOTE:
Refer to Fastener Notice
.