Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2007 >> Relay 3.9 1 >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Power Door Lock System And Release Systems) >> Diagnostic Information and Procedures >> Power Liftgate Inoperative >> Component Testing >> I/P Switch Assembly

I/P Switch Assembly

WARNING: This page is about a different car, the 2007 Saturn Outlook. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the I/P Switch Assembly.
  2. Test for infinite resistance between the signal circuit terminal 7 and the ground circuit terminal 3 with the liftgate open switch in the inactive position.
    • If not the specified value, replace the I/P Switch Assembly.
  3. Test for infinite resistance between the signal circuit terminal 8 and the ground circuit terminal 3 with the liftgate disable switch in the inactive position.
    • If not the specified value, replace the I/P Switch Assembly.
  4. Test for less than 3 ohms between the signal circuit terminal 7 and the ground circuit terminal 3 with the liftgate open switch in the active position.
    • If greater than the specified range, replace the I/P Switch Assembly.
  5. Test for less than 3 ohms between the signal circuit terminal 8 and the ground circuit terminal 3 with the switch in the disable position.
    • If greater than the specified range, replace the I/P Switch Assembly.
scientia non olet · About Mike's Workshop Manuals