Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2007 >> Relay 3.9 1 >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition and Start Switch Replacement >> Removal Procedure

Removal Procedure

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  3. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  4. Remove the theft deterrent module from the lock cylinder housing. Refer to Theft Deterrent Module Replacement .
    5. Fig 1: Removing/Installing Ignition Switch
    GM1540116Courtesy of GENERAL MOTORS CORP.
  5. Remove the screws (2) from the ignition switch (1).
  6. Remove the ignition switch (1) from the ignition lock cylinder case.
  7. Disconnect the ignition switch electrical connector.
scientia non olet · About Mike's Workshop Manuals