Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2007 >> Outlook XE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 602 (Power Door Lock System And Release Systems) >> Repair Instructions >> Sliding Door Lock Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Relay. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Sliding Door Lock Module Mounting Components
    GM1480590Courtesy of GENERAL MOTORS CORP.
  1. Position the lock module to the inner door.
  2. Connect the lock rods (4).
  3. Connect the electrical connector (3).
  4. Connect the door lock release cable to the lock module.
  5. Position the lock module to the door.
  6. Install the lock module screws (1).
    7. NOTE: Refer to Fastener Notice .
  7. Install the forward mounting bracket screws.

    Tighten: 

    1. Tighten the screws, in sequence as shown, to 10 N.m (89 lb in).
    2. Tighten the top screw (1) to 10 N.m (89 lb in).

  8. Ensure the rear latch rod is secured into the sliding door insulator guide.
    9. Fig 2: Identifying Door Inner Water Deflector
    GM1480598Courtesy of GENERAL MOTORS CORP.
  9. Install the water deflector. Refer to Rear Side Door Water Deflector Replacement .
  10. Close the sliding door.
    11. IMPORTANT: By installing the 15A fuse, the low current logic power will be restored to both the LH and RH PSDMs and the PSDs will be operational. However, both PSDMs will have to learn the full open and full closed positions of the PSD. Refer to Rear Side Door Actuator Control Module Programming and Setup .
  11. If equipped with a power sliding door, enable the PSD system by installing the PSD 15A fuse into the I/P fuse block.
scientia non olet · About Mike's Workshop Manuals