Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2007 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Engine Mechanical) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Saturn Ion Red Line. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the engine mount onto the midrail and hand start the nuts.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Tighten the engine mount to midrail nuts.

    Tighten:  Tighten the nuts to 100 N.m (74 lb ft).

    3. Fig 1: View Of Engine Mount
    GM851555Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The engine mount to intermediate bracket bolts must be hand started. Do not pry the engine mount to align the holes.
  3. Hand start the engine mount to intermediate bracket bolts.
  4. Tighten the engine mount to intermediate bracket bolts, starting with the center bolt.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    5. Fig 2: View Of Engine Mount To Intermediate Bracket Bolts
    GM851553Courtesy of GENERAL MOTORS CORP.
  5. Remove the hydraulic floor jack.
scientia non olet · About Mike's Workshop Manuals