Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2007 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Antilock Brake System And Traction Control System) >> Repair Instructions >> Brake Pressure Modulator Valve (BPMV) Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Saturn Ion Red Line, 2004 Saturn Ion 3, 2004 Saturn Ion 2, and 2004 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the OFF position.
  2. Release the electronic brake control module (EBCM) wiring harness retainer from the brake pressure modulator valve (BPMV) bracket.
    3. Fig 1: View Of EBCM Electrical Connector
    GM890987Courtesy of GENERAL MOTORS CORP.
  3. Loosen the 2 insulator nuts (1) on the BPMV assembly.
    4. Fig 2: Locating BPMV Insulator Nuts
    GM890990Courtesy of GENERAL MOTORS CORP.
  4. Carefully lift the brake modulator assembly just enough to clear the bracket, then support the assembly.
  5. Release the forward lamp wiring harness from the BPMV bracket.
    6. Fig 3: View Of Forward Lamp Wiring Harness At BPMV Bracket
    GM891778Courtesy of GENERAL MOTORS CORP.
  6. Remove the brake pressure modulator assembly bracket mounting nut and mounting bolts.
  7. Remove the bracket from the vehicle.
    8. Fig 4: View Of BPMV Bracket
    GM890992Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals