Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2007 >> Ion 2 4D Sedan, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 160 (Cellular Communication System) >> Repair Instructions >> Bracket Assembly Replacement - OnStar Module >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Saturn Ion Red Line, 2006 Saturn Ion 3, and 2006 Saturn Ion 2. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Vehicle Communication Interface Module
GM888377Courtesy of GENERAL MOTORS CORP.
  1. Install the OnStar® bracket to the rear shelf.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the OnStar® bracket screw.

    Tighten:  Tighten the screw to 2.5 N.m (23 lb in).

  3. Install the CIM in the bracket.
  4. Install the rear shelf trim. Refer to Trim Panel Replacement - Rear Window Shelf (Late Production) in Interior Trim.
scientia non olet · About Mike's Workshop Manuals