Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2007 >> Aura Green Line >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wipers System And Washer System >> Repair Instructions >> Wiper Drive System Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Wiper Motor
    GM1471742Courtesy of GENERAL MOTORS CORP.
  1. Install the wiper motor. Refer to Windshield Wiper Motor Replacement .
  2. Connect the electrical connector to the wiper motor.
  3. Connect the clip retaining the electrical harness to the wiper module.
    4. Fig 2: Identifying Wiper System Module
    GM1471736Courtesy of GENERAL MOTORS CORP.
  4. Position the wiper module assembly into the plenum.
    5. NOTE: Refer to Fastener Notice .
  5. Install the fasteners attaching the wiper module assembly to the plenum.

    Tighten:  Tighten the fasteners to 10 N.m (89 lb in).

  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  7. Install the wiper arms. Refer to Windshield Wiper Arm Replacement .
  8. Inspect the washers for proper operation.
scientia non olet · About Mike's Workshop Manuals