Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 165 (Engine Controls - 3.5L (L66) Introduction) >> Repair Instructions >> Fuel Rail Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install new O-rings to the injectors.
  2. Install the fuel rail and injectors as an assembly to the manifold.
    Fig 1: Exploded View Of Fuel Rail Assembly
    GM1237804Courtesy of GENERAL MOTORS CORP.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolts.

    Tighten:  Tighten the bolts to 9.8 N.m (87 lb. in.).

  4. Connect the fuel injector electrical connectors.
  5. Install the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical.
  6. Inspect for fuel leaks using the following procedure:
    1. With the engine OFF, turn ON the ignition for 2 seconds.
    2. Inspect for fuel leaks.
    3. Turn the ignition OFF for at least 10 seconds.
    4. With the engine OFF, turn ON the ignition for 2 seconds.
    5. Inspect for fuel leaks.
    6. Turn the ignition OFF.
scientia non olet · About Mike's Workshop Manuals