Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2006 >> Relay 3.5 L, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.5L - Introduction (2 Of 2) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Camshaft Position Sensor
    GM909619Courtesy of GENERAL MOTORS CORP.
  1. Turn OFF the ignition.
  2. Remove the power steering pump. Refer to Power Steering Pump Replacement .
  3. Disconnect the camshaft position (CMP) sensor electrical connector.
  4. Remove the attaching bolt.
  5. Remove the CMP sensor.
  6. Inspect the CMP sensor O-ring for wear, cracks, or leakage if the sensor is not being replaced.
scientia non olet · About Mike's Workshop Manuals