Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2006 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Engine Controls - Introduction) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement (SCIP) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Saturn Ion Red Line. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the supercharger inlet pressure (SCIP) sensor harness connector.
  2. Remove the SCIP sensor (1) from the supercharger.
    3. Fig 1: Locating SCIP Sensor & BARO Sensor
    GM1389393Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: If the SCIP sensor seal is damaged, the SCIP sensor must be replaced.
  3. Inspect the seal for damage.
scientia non olet · About Mike's Workshop Manuals