Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2005 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.2L (L61) Introduction) >> Repair Instructions >> Knock Sensor (KS) Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Remove the knock sensor harness connector.
  3. Remove the knock sensor connector from the retaining clip by inserting a flat-bladed screwdriver between the connector and clip while sliding the connector upward.
  4. Remove the knock sensor.
    Fig 1: Removing & Installing Knock Sensor
    GM895903Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals