Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2005 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.2L (L61) Introduction) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement .
  2. Disconnect the fuel pump module harness electrical connector from the fuel tank pressure sensor.
    Fig 1: View Of Fuel Pump Module And Fuel Tank Pressure Sensor Electrical Connectors
    GM889969Courtesy of GENERAL MOTORS CORP.
  3. Position 2 flat-bladed screwdrivers, one on each side of the sensor, near the vacuum port.
  4. Carefully use the screwdrivers to lift and release the sensor from the fuel pump module.
    Fig 2: View Of Fuel Tank Pressure Sensor
    GM889971Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals