Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2005 >> Vue Red Line, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.5L (L66) Introduction >> Repair Instructions >> Fuel Pressure Gage Installation and Removal >> Installation Procedure

Installation Procedure

  1. Remove the intake air duct with resonator from the engine. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  2. Connect one end of the gage hose (1) from the SA9127E  , to the fuel shut off and bleed assembly (5).
  3. Connect the other end of the gage hose (1) to the fuel pressure gage side of the gage bar set (2).
    Fig 1: View Of Fuel Pressure Gage
    GM1349422Courtesy of GENERAL MOTORS CORP.
  4. Remove the Schrader valve cap.
  5. Connect the fuel shut off and bleed assembly (5) to the Schrader valve on the fuel feed pipe (4) near the fuel rail. Use a shop towel in order to catch any remaining fuel that may leak.
  6. Use the scan tool, in order to pressurize the fuel system. Refer to Scan Tool Output Controls .
  7. Use the drain hose (3) of the fuel shut off and bleed assembly (5) to bleed any trapped air from the lines and hoses.
  8. After bleeding the lines and hoses, pressurize the fuel system.
  9. Inspect for any fuel leaks.
scientia non olet · About Mike's Workshop Manuals