Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2005 >> Vue Base, 2.2 D, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L (L66) Introduction) >> Repair Instructions >> Rocker Arm Oil Pressure Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View Of Oil Flow Control Module
    GM1236195Courtesy of GENERAL MOTORS CORP.
  1. Install the NEW O-ring and switch.

    Tighten:  Tighten the switch to 22 N.m (16 lb. ft.).

  2. Install the splash shield. Refer to Splash Shield Replacement - Engine in Body Front End.
  3. Install the wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals