Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2005 >> Vue Base, 2.2 D, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L (L66) Introduction) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Make sure the MAP sensor mounting surface is clean. Install the MAP sensor with the new O-ring and attachment bolt (6).

    Tighten:  Tighten the manifold absolute pressure sensor screw to 4 N.m (35 lb. in.).

  2. Connect the MAP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.
    Fig 1: View Of Manifold Absolute Pressure (MAP) Sensor
    GM1233528Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals