Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2005 >> Vue Base, 2.2 D, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L (L66) Introduction) >> Repair Instructions >> Intake Air Temperature (IAT) Sensor 2 Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the IAT sensor to the side of the intake manifold (5).

    Tighten:  Tighten the IAT sensor to 18 N.m (13 lb. ft.).

  2. Connect the IAT sensor harness connector. Push in the connector until a click is heard, then pull back to confirm a positive engagement.
    Fig 1: View Of Intake Air Temperature (IAT) Sensor 2
    GM1233528Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals