Inflatable Restraint Side Impact Sensor Replacement

Fig 1: Identifying Inflatable Restraint Side Impact Sensor

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs. NOTE: Refer to Fastener Notice in Cautions and Notices. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
Preliminary Procedures Disable the supplemental Inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling Zone 6 . Remove the center pillar lower trim. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
1	Connector, Side Impact Sensor Electrical Tip: Remove the connector position assurance (CPA) from the yellow harness connector.
2	Bolt, Inflatable Restraint Side Impact Sensor (Qty: 2) Tip: Loosen the bolts only. Tighten: 10 N.m (89 lb in)
3	Sensor, Inflatable Restraint Side Impact