Removal Procedure

WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Refer to SIR Inflator Module Handling and Storage Caution in Cautions and Notices.

CAUTION: A deployed dual stage inflator module will look the same whether one or both stages were used. Always assume a deployed dual stage inflator module has an active stage 2. Improper handling or servicing can activate the inflator module and cause personal injury.

CAUTION: Refer to SIR Caution in Cautions and Notices.

Disable the SIR system. Refer to SIR Disabling and Enabling Zone 5 .
Remove the trim pad from the instrument panel (I/P). Refer to Instrument Panel (I/P) Assembly Replacement .

Fig 1: Identifying Inflator Restraint Module Bracket Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

Disconnect the inflator module connector.
Remove the 4 bolts from the inflator restraint module bracket.
Remove the inflatable restraint module from the I/P.
Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .