Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Control System - 3.5L (Lx9) - Introduction) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Throttle Body
    GM1239002Courtesy of GENERAL MOTORS CORP.
  1. Install a new gasket, if necessary.
  2. Install the throttle body assembly.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the throttle body nuts and the bolts.

    Tighten:  Tighten the nuts and the bolts to 10 N.m (89 lb in).

    4. Fig 2: Removing Heater Pipe Nut At Throttle Body
    GM1239021Courtesy of GENERAL MOTORS CORP.
  4. Install the heater pipe nut to the throttle body.

    Tighten:  Tighten the nut to 25 N.m (18 lb ft).

  5. Connect the ETC electrical connector.
  6. Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
scientia non olet · About Mike's Workshop Manuals