Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Control System - 3.5L (Lx9) - Introduction) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing MAP Sensor And MAP Sensor Seal From Upper Intake Manifold
    GM1239001Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor and MAP sensor seal into the upper intake manifold.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the MAP sensor attaching screw.

    Tighten:  Tighten the attaching screw to 6.5 N.m (5.7 lb in).

  3. Connect the MAP sensor electrical connector.
scientia non olet · About Mike's Workshop Manuals