Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Control System - 3.5L (Lx9) - Introduction) >> Repair Instructions >> Fuel Level Sensor & Fuel Pump Module Replacement (Malibu Sedan) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Pump Module Assembly (Malibu Sedan)
    GM1236147Courtesy of GENERAL MOTORS CORP.
  1. Carefully slide the fuel level sensor into the slots on the fuel pump module bowl.
  2. Secure the retaining tab on the sensor into the slot on the pump module bowl.
  3. Connect the fuel level sensor electrical connector to the pump module cover.
  4. Install the fuel level sensor wiring harness to the molded-in tab on the pump module bowl.
  5. Install the fuel pump module assembly. Refer to Fuel Sender Assembly Replacement (Malibu Sedan)  or Fuel Sender Assembly Replacement (Malibu MAXX) .
scientia non olet · About Mike's Workshop Manuals