Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.5L - DTC P0446 - P1404 >> DTC Tests >> DTC P1112 >> Conditions for Clearing the DTC

Conditions for Clearing the DTC

DTC P1112

Step Action Yes No
Schematic Reference: Engine Controls Schematics
Connector End View Reference: Engine Controls Connector End Views or Powertrain Control Module (PCM) Connector End Views
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 Observe the DTC Information with a scan tool.
Is DTC P0112 set?
Go to DTC P0112 Go to Step 3 
3 Test the intake air temperature (IAT) signal circuit between the IAT sensor and the powertrain control module (PCM) for an intermittent short to ground. Refer to Inducing Intermittent Fault Conditions ,Testing for Intermittent Conditions and Poor Connections , and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 4  Go to Intermittent Conditions
4
  1. Clear the DTCs with a scan tool.
  2. Turn OFF the ignition for 60 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running in the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Did the DTC fail this ignition?
Go to Step 2  Go to Step 5 
5 Observe the Capture Info with a scan tool.
Are there any DTCs that have not been diagnosed?
Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information System OK