Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Rear Parking Assist System >> Repair Instructions >> Object Alarm Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Electrical Connector & Rear Object Detection Module
    GM733623Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Align the rear object detection module to the vehicle.
  2. Install the rear object detection module mounting bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Install the electrical connector to the rear object detection module and press in the locking tab.
  4. Install the rear compartment side trim. Refer to Trim Panel Replacement - Rear Quarter - Right in Interior Trim.
scientia non olet · About Mike's Workshop Manuals