Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2005 >> L300 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - Introduction & Repair Instructions >> Repair Instructions >> Low/Reverse Servo Assembly Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Removing & Installing Low/Reverse Servo Assembly
    GM893229Courtesy of GENERAL MOTORS CORP.
    CAUTION: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
  1. Position the vehicle on a hoist and raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the transaxle oil pan. Refer to Oil Pan Replacement .
  3. Remove the oil feed pipe-to-low/reverse servo assembly bolt.
    4. IMPORTANT: Remove servo cover bolts evenly to prevent damage to servo cover.
  4. Remove the low and reverse band servo cover assembly bolts.
  5. Pull the oil feed pipe away from the servo cover and remove the servo assembly.
scientia non olet · About Mike's Workshop Manuals