Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2005 >> L300 >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Engine Controls - 3.0L (L81) (Introduction)) >> Repair Instructions >> Ignition Control Module Replacement - Bank 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ignition module.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the ignition module bolts. Tighten:  Tighten the ignition module bolts to 8 N.m (71 lb in).
    3. Fig 1: Removing & Installing Ignition Control Module
    GM894329Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals