Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2004 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 232 (Engine Controls - 2.2L (L61) Introduction) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the MAP sensor with port seal into the intake manifold.
    Fig 1: View Of Manifold Absolute Pressure Sensor
    GM897253Courtesy of GENERAL MOTORS CORP.
  2. Connect the MAP sensor electrical connector. Push in the connector until a click is heard and pull back to confirm a positive engagement.
  3. Install the outlet resonator/duct assembly into position.
  4. Connect the PCV fresh air vent hose assembly.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Tighten the clamp at the throttle body assembly.

    Tighten:  Tighten the clamp to 4 N.m (36 lb. in.).

  6. Position the outlet resonator/duct assembly up with the support bracket and install the push-pin.
  7. Tighten the clamp at the air cleaner assembly.

    Tighten:  Tighten the clamp to 4 N.m (36 lb. in.).

  8. Connect the IAT sensor connector.
scientia non olet · About Mike's Workshop Manuals