Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2004 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 162 (Engine Controls - Introduction) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Crankshaft Position Sensor
    GM894668Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Disconnect the crankshaft position (CKP) sensor harness connector.
    3. CAUTION: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
  3. Raise the vehicle.
  4. Remove the CKP sensor attachment bolt and remove the sensor. Make sure the O-ring is removed.
scientia non olet · About Mike's Workshop Manuals