Installation Procedure
- Route the battery cable through the engine compartment and connect to the cable retainers.
- Connect the positive battery cable to the generator.
- Connect the positive battery cable to the starter (2).
- Connect the positive battery cable to the UHJB (2).
Tighten: Tighten the positive cable to UHJB to 17 N.m (13 lb ft).
- Install the UHJB cover (1).
- Connect the positive battery cable to the battery.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.