Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2004 >> Vue Base, 2.2 D, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls (Introduction) -- 3.5L (L66)) >> Repair Instructions >> Powertrain Control Module (PCM) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Powertrain Control Module (PCM)
    GM1226486Courtesy of GENERAL MOTORS CORP.
  1. Install the PCM into the housing bracket.
  2. Connect the wiring harness.
  3. Connect the battery negative cable. Refer toBattery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  4. Program the PCM. Refer toService Programming System (SPS) in Programming.
  5. Perform the Idle Learn procedure. Refer toIdle Learn Procedure .
scientia non olet · About Mike's Workshop Manuals