Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2004 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Antilock Brake System And Traction Control System) >> Diagnostic Information and Procedures >> Traction Control Indicator Inoperative >> Test Description

Test Description

WARNING: This page is about a different car, the 2005 Saturn Ion Red Line, 2005 Saturn Ion 3, 2005 Saturn Ion 2, and 2005 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  Confirm if the scan tool can turn on and off all the indicator lamps in the instrument cluster.
  1. 4:  Verify if the circuits going to the instrument Cluster or the cluster is at fault.
Traction Control Indicator Inoperative

Step Action Yes No
Schematic Reference: ABS Schematics 
Connector End View Reference: Computer/Integrating Systems Connector End Views in Computer/Integrating System
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 
  1. Using a scan tool, select the body control module (BCM) Special Functions mode.
  2. Select Chassis Data Displays Test in Output Control.
  3. In the Displays Test mode you can turn the TRAC OFF Switch LED indicator ON or OFF.

    All indicators will turn ON when commanded ON.

Does the TRAC OFF Switch LED Indicator turn ON?		 Go to Step 4  Go to Step 3 
3
  1. Using a scan tool, select the BCM Data Display mode.
  2. Select Chassis Data Display.
  3. In the Displays Test mode, monitor the TRAC LED indicator.

    Press the TRAC switch. The LED should change states.

Does the scan tool display ON with TRAC switch pressed?		 Go to Step 8  Go to Step 7 
4  Measure the voltage at the TRAC switch between terminal D and ground.
Is voltage present?		 Go to Step 6  Go to Step 5 
5 Test the traction control switch signal circuit for an open.
Did you find and correct the condition?		 Go to Step 12  -
6 Activate the TRAC OFF switch, switch activated.
Measure the voltage at the TRAC switch between terminal A and ground.
Is voltage present?		 Go to Diagnostic Aids Go to Step 10 
7 Test the traction control switch ground circuit for an open.
Did you find and correct the condition?		 Go to Step 12  Go to Step 11 
8 Measure the voltage at the TRAC switch between terminal C and ground.
Is voltage present?		 Go to Step 10  Go to Step 9 
9 Test the traction control indicator control circuit for an open or short to ground.
Did you find and correct the condition?		 Go to Step 12  -
10 Replace the traction control switch. Refer to Traction Control Switch Replacement  in Body Control System.
Did you find and correct the condition?		 Go to Step 12  -
11 Replace the BCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Is the replacement complete?		 Go to Step 12  -
12 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 2 
scientia non olet · About Mike's Workshop Manuals