Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2004 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Engine Controls And Fuel - Introduction (2 Of 2)) >> Repair Instructions >> Spark Plug Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Ion Red Line. However, it is still accessible from the selected car via links, so may be relevant.
  1. Gap the spark plug, using round wire type spark plug gap gage.

    Gap:  Adjust the spark plug gap to 1.14 mm (0.045 in).

    2. Fig 1: Identifying Spark Plugs
    GM1339183Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
    IMPORTANT: DO NOT coat the spark plugs with anti-seize compound. Over torquing could occur and damage to the cylinder head threads may result.
  2. Install the spark plugs with a spark plug socket.

    Tighten:  Tighten the spark plugs to 20 N.m (15 lb ft).

  3. Install the ignition coils. Refer to Ignition Coil Replacement .
scientia non olet · About Mike's Workshop Manuals