Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2004 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Engine Controls And Fuel - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement (TMAP) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Ion Red Line. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating TMAP Sensor
    GM1382191Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Use the new TMAP sensor seal provided with the new TMAP sensor.
    NOTE: Refer to Fastener Notice .
  1. Install the TMAP sensor into the intake manifold.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  2. Connect the TMAP sensor harness connector.
scientia non olet · About Mike's Workshop Manuals