Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2004 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Engine Controls And Fuel - Introduction (2 Of 2)) >> Repair Instructions >> Intake Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Ion Red Line. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating ECT Sensor, Boost Control Solenoid, & IAT Sensor
    GM1389396Courtesy of GENERAL MOTORS CORP.
  1. Press the IAT sensor (3) into the engine.
    2. NOTE: Refer to Fastener Notice .
  2. Install the IAT sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  3. Connect the IAT sensor harness connector.
scientia non olet · About Mike's Workshop Manuals