Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2004 >> Ion 1 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Instrument Panel Trim And Console Trim) >> Repair Instructions >> Front Floor Console Extension Replacement - Center >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Ion Red Line, 2007 Saturn Ion 3, and 2007 Saturn Ion 2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Console Center Extension Screws
    GM873754Courtesy of GENERAL MOTORS CORP.
  1. Align the retaining fasteners on the console center extension with the instrument panel (I/P) retainer. Push the extension to secure.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the console center extension screws.

    Tighten:  Tighten the console center extension screws to 2.5 N.m (22 lb in).

    3. Fig 2: View Of Cigar Lighter Electrical Connector
    GM877759Courtesy of GENERAL MOTORS CORP.
  3. If equipped with a manual transmission, slide the shift boot through the front console cupholder.
  4. Connect the cigar lighter electrical connector.
    5. Fig 3: View Of Front Console Cupholder
    GM873757Courtesy of GENERAL MOTORS CORP.
  5. Align the retaining fasteners on the front console cupholder with the console.
  6. Push the front console cupholder to secure.
    7. Fig 4: View Of Console Shift Boot
    GM873756Courtesy of GENERAL MOTORS CORP.
  7. If equipped with a manual transmission, snap the shift boot to the front console cupholder.
    8. Fig 5: View Of Shift Lever Bezel
    GM873755Courtesy of GENERAL MOTORS CORP.
  8. If equipped with an automatic or VTi transmission, align the fingers on the shift lever bezel with the slots on the shift lever base. Push the console shift lever bezel to secure.
  9. If equipped with an automatic or VTi transmission, shift the transmission into Park.
    10. Fig 6: View Of Console Side Extension
    GM873753Courtesy of GENERAL MOTORS CORP.
  10. Install the console side extensions.
  11. Align the clips on the console side extensions with the slots in the console.
  12. Slide the console side extensions forward to engage the clips with the console.
    13. Fig 7: View Of Console Side Extension Retainer
    GM877755Courtesy of GENERAL MOTORS CORP.
  13. Install the console side extension retainers and turn clockwise to secure.
scientia non olet · About Mike's Workshop Manuals