DOHC / LL0 Adjustment
- Observe the position of the throttle linkage to ensure the linkage is resting on the throttle stop screw.
- Depress the cruise cable adjuster release tabs and slide the adjuster away from the module.
- Move the adjuster in toward the module until the accelerator cable spring just touches the cruise cable adjuster.
- Move the cable adjuster (2) one click toward the module (1). There should be a 1-2 mm (0.040-0.079 in) (4) compression of the spring. There now should be no play in the accelerator cable. The spring should be 1-2 mm compressed and the throttle linkage should be resting on the stop screw.
NOTE:
Driveability concerns may result if the cruise control rod is not adjusted properly.
IMPORTANT:
1-2 mm (0.040-0.079 in) is approximately one click movement of the adjuster.
IMPORTANT:
At this point the spring should NOT be compressed.