Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2002 >> SL >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control System -- "S" Series >> Repair Instructions >> Cruise Control System Installation >> Install New Steering Wheel and Inflator Module

Install New Steering Wheel and Inflator Module

    Fig 1: Installing Steering Wheel With NEW Attachment Nut
    GM862539Courtesy of GENERAL MOTORS CORP.
  1. Remove the yellow tab or tape from the SIR coil assembly.
  2. Route wiring through the steering wheel and install the steering wheel onto the steering shaft noting orientation notch that locates steering wheel in the correct position.
    3. IMPORTANT: A new steering wheel attachment nut must be used.
  3. Install the new steering wheel attachment nut.

    Tighten:  Tighten the steering wheel attachment nut to 40 N.m (30 lb ft).

    4. Fig 2: Locating Steering Wheel Electrical Connectors
    GM862526Courtesy of GENERAL MOTORS CORP.
  4. Connect the cruise control switch connector and attach the harness to the wheel. Push in the connectors until a click is heard and pull back to confirm a positive engagement.
    5. Fig 3: Inflator Module
    GM862544Courtesy of GENERAL MOTORS CORP.
  5. Connect the inflator module wiring harness and install the harness integral connector lock device.
  6. Install the inflator module into the steering wheel. Be sure to seat all attachment points.
  7. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM in AIR BAG RESTRAINT SYSTEMS article in RESTRAINTS.
scientia non olet · About Mike's Workshop Manuals