Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2000 >> SC2 Automatic, MP6 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Basic Diagnostic Procedures >> No Start Diagnosis >> No Start - Engine Cranks Okay (4.6L) >> Ignition System

Ignition System

  1. Perform OBD system check. See ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK in appropriate SELF-DIAGNOSTICS article. After performing OBD system check, go to next step.
  2. If DTCs P0335, P0340 and P0385 are set, go to next step. If listed DTCs are not set, go to step  4 .
  3. Check for short to ground in CKP and CMP ignition feed circuits, or shorted CKP or CMP sensors. Repair as necessary. After repairs, go to step  12 .
  4. Check all fuses supplying ignition voltage to each ignition control assembly and fuel injectors. If a fuse is open, repair short to ground in affected circuit and replace fuse. After repairs, go to step  12 . If fuses are okay, go to next step.
  5. Using scan tool, check for skewed TP sensor or ECT sensor. Check for skewed or unresponsive MAP sensor. Repair as necessary. After repairs, go to step  12 . If sensors are okay, go to next step.
  6. Turn ignition off. Connect fuel pressure gauge. See BASIC FUEL SYSTEM CHECKS  . Turn ignition on. Check fuel pressure. If pressure is 41-47 psi (2.9-3.3 kg/cm2 ), go to step  8 . If pressure is not as specified, go to next step.
  7. If fuel pressure is indicated, check fuel system. See FUEL SYSTEM in appropriate SYSTEM & COMPONENT TESTING article. If fuel pressure is not indicated, see FUEL PUMP ELECTRICAL CIRCUIT  .
  8. Check for faulty MAF sensor. Replace if necessary. After repairs, go to step  12 . If MAF sensor is okay, go to next step.
  9. Check for fouled spark plugs. Replace if necessary. After repairs, go to step  12 . If spark plugs are okay, go to next step.
  10. Check for faulty splice connection in battery feed circuit to both ignition control module assemblies. Repair as necessary. After repairs, go to step  12 . If circuit is okay, go to next step.
  11. Check for engine mechanical problems. Repair as necessary. After repairs, go to next step. If no problem is found, check for intermittent problem. See appropriate TROUBLE SHOOTING - NO CODES article.
  12. Using scan tool, clear DTCs. Attempt to start engine If engine starts and runs, go to next step. If engine does not start, go to step  2 .
  13. Allow engine to reach normal operating temperature. Using scan tool, check for DTCs. If any DTCs set, diagnose DTCs. See appropriate SELF-DIAGNOSTICS article. If no DTCs are set, system is okay.
scientia non olet · About Mike's Workshop Manuals