Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2000 >> LS2 Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Servicing - A/T >> Removal & Installation >> Low/Reverse Servo Assembly >> Installation

Low/Reverse Servo Assembly: Installation

CAUTION: Hand start and tighten servo cover bolts evenly to prevent damage to servo cover bore.
  1. Install servo return spring into transaxle case. Install servo cover and piston assembly over servo return spring. Hand start and install servo cover bolts. Tighten servo cover bolts to specification. See TORQUE SPECIFICATIONS .
  2. Lower vehicle. Remove clamp from A.I.R. hose behind cooling fan. Separate A.I.R. tube from hose and push tube back toward transaxle. See Figure. Note original position of A.I.R. components. Add DEXRON-III ATF to specified refill capacity. See FLUID CAPACITIES  under LUBRICATION.
  3. Start engine, warm up transaxle, and check for leaks. Check fluid level. See CHECKING FLUID LEVELS  under LUBRICATION.
scientia non olet · About Mike's Workshop Manuals