ACP Snapshot Test
WARNING: This page is about a different car, the 1995 Cadillac Seville, 1995 Cadillac Eldorado, and 1995 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
- Selecting snapshot test type while in ACP system level allows up to 3 snapshots, recorded at time of setting ACP trouble codes, to be recalled. A snapshot can also be recorded upon demand.
- Selecting snapshot (pressing blower fan up arrow (HI) button) while in ACP system results in display of X### SNAPSHOT (### is 3-digit trouble code). See Figure and Figure
. When selecting snapshot test type, several options are available:
- Press blower fan down arrow (LO) button to scroll through ACP trouble codes list for snapshots stored in memory. After last ACP code (or third, if more than 3 codes are set), pressing LO button results in display of TAKE SNAPSHOT? message. Pressing LO button again will return to first X### SNAPSHOT? display.
- Pressing blower fan up arrow (HI) button at X### SNAPSHOT display changes display to X### DATA or SNAP DATA message to select snapshot data values. See ACP DATA DISPLAY CODES. Press HI button to select a data test or press LO button to go to X### INPUTS or SNAP INPUTS selection. Pressing HI button here selects input test. Pressing LO button here will display X### DATA or SNAP DATA screen again. At each data or input test, display is controlled as it would be for non -snapshot data and input displays; however, all values and status information represent memorized vehicle conditions.
- Pressing HI button with TAKE SNAPSHOT displayed will display SNAPSHOT TAKEN message to indicate new information has been stored in memory. After a few seconds, display will change to X### DATA or SNAP DATA screen.
- Pressing OFF with X### SNAPSHOT displayed will return display to next available test selection.