Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2011 >> 9-5 Turbo4, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Basic Engine, V6) >> Adjustment Replacement >> Valve Spring Inspection and Measurement >> Measurement Procedure

Measurement Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Measure the valve spring tension using the EN 22738-B  tester. Refer to Engine, Mechanical Specifications (LAU) .
    Fig 1: Measuring Valve Spring Tension Using Tool
    G09438806Courtesy of SAAB-SCANIA OF AMERICA, INC.
  2. If a low valve spring loading is observed, the valve springs must be replaced. Do not use a shim to increase the spring loading. The use of shims can cause the valve spring to bottom out before the camshaft lobe is at peak lift.
scientia non olet · About Mike's Workshop Manuals