Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2011 >> 9-4X 3.0i, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Management And Fuel System, V6 >> Fault diagnosis, fault codes >> DTC P0130: HO2S Circuit Closed Loop Performance Sensor 1 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the B52 HO2S 1.
  2. Ignition ON, verify that the scan tool HO2S 1 parameter is between 350-500 mV.
  3. If greater than the specified range, test the signal circuit of the HO2S 1 for a short to the heater circuit. If the circuit/connections test normal, replace the K20 ECM.
  4. If all circuits/connections test normal, replace the B52 HO2S 1.
scientia non olet · About Mike's Workshop Manuals