Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2011 >> 9-3X Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (General Electrical) >> Repair Instructions - Control Modules >> Control module, fuel pump (697) >> To remove

To remove

WARNING: This page is about a different car, the 2009 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
  1. 4D/5D:  Remove the right front seat.

    CV:  Remove the seat cushion of the rear seat.

  2. 4D/5D:  Fold up the right corner of the rear carpeting.
  3. Lift up the control module slightly and unplug the connector.
    IMPORTANT: Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the halves straight apart to avoid bending the pins. For further information regarding connectors, refer to CONNECTORS, HANDLING AND INSPECTION .
    Fig 1: Illustration For Steps 3-4
    G05571108Courtesy of SAAB-SCANIA OF AMERICA, INC.
  4. Cut the cable tie holding the control module to the insulation.
scientia non olet · About Mike's Workshop Manuals